Deutsch
English
Italiano
RHBL-Écrou en laiton à pression avec tete tete 5,5-h.4,7-trou 4 M3x4,7
N° d'article
0340300.01000
Quantité multiple 1000
Brass . Installation by press fitting . They are press-in expansion brass rivet nuts, used in hard thermosetting plastics. After installation the rivet nut is a little bit self-locking . The rivet nuts for plastics are designed to be installed after the moulding. Benefits of this solutions are: • It
Lire la description complète
Description
Brass.
Installation by press fitting.
They are press-in expansion brass rivet nuts, used in hard thermosetting plastics.
After installation the rivet nut is a little bit self-locking.
The rivet nuts for plastics are designed to be installed after the moulding.
Benefits of this solutions are:
• It is possible to place rivet nuts away from the moulding zone.
• "Press open" time reduced, consequent increase of the productivity.
• Scrap rate reduced, the risk of shifting of the rivet nuts during the moulding is eliminated.
• Installation can be automated.
While choosing always consider the type of plastics and the installation process.
Installation by press fitting.
They are press-in expansion brass rivet nuts, used in hard thermosetting plastics.
After installation the rivet nut is a little bit self-locking.
The rivet nuts for plastics are designed to be installed after the moulding.
Benefits of this solutions are:
• It is possible to place rivet nuts away from the moulding zone.
• "Press open" time reduced, consequent increase of the productivity.
• Scrap rate reduced, the risk of shifting of the rivet nuts during the moulding is eliminated.
• Installation can be automated.
While choosing always consider the type of plastics and the installation process.
Caractéristiques
| Marchio Statim | Rivit |
| modèle | RHBL030 |
| diamètre (mm) | M3 |
| diamètre du trou (mm) | 4,0 |
| T (mm) | 5,5 |
| k (mm) | 0,51 |
| L - longueur (mm) | 3,2 |
| spessore parete (mm) | 3,2 |