This website uses cookies to enhance your experience.

MALCO-Fresatrice per fori circolari d.50/500 HC2

Item No.: 1903400
Multiple quantity: 1
Hole cutter compass type. HC1 and HC2 hole cutters can be used, with any drill, to cut holes in sheet metal, pipes, especially to connect a lateral pipe to the main line. The cutting bit, not only drills straight, but also laterally (diameter 50mm to 500mm). Use: First adjust the diameter of
Read full description
This product cannot be ordered at the moment.
Description
Hole cutter compass type.
HC1 and HC2 hole cutters can be used, with any drill, to cut holes in sheet metal, pipes, especially to connect a lateral pipe to the main line.
The cutting bit, not only drills straight, but also laterally (diameter 50mm to 500mm).
Use:
First adjust the diameter of the section and then drill the center hole.
Place the pivot pin into the center hole and mill the material.
In the initial phase rotate the tool about 10cm clockwise.
The change of grip completes the round cut.
Technical specifications
Marchio Statim Malco
model HC2
length (mm) 280
hole diameter (mm) 51 - 508
Loading
Loading