Deutsch
English
Italiano
RPLK-Écrou en laiton à pression h.12,7 trou 9,6 M8x12,7
N° d'article
1878500
Quantité multiple 1
Brass . Installation by press fitting . They are designed for quick installation, used in soft and medium thermoplastics. After installation the rivet nut is a little bit self-locking . The rivet nuts for plastics are designed to be installed after the moulding. Benefits of this solutions are: • It
Lire la description complète
Description
Brass.
Installation by press fitting.
They are designed for quick installation, used in soft and medium thermoplastics.
After installation the rivet nut is a little bit self-locking.
The rivet nuts for plastics are designed to be installed after the moulding.
Benefits of this solutions are:
• It is possible to place rivet nuts away from the moulding zone.
• "Press open" time reduced, consequent increase of the productivity.
• Scrap rate reduced, the risk of shifting of the rivet nuts during the moulding is eliminated.
• Installation can be automated.
While choosing always consider the type of plastics and the installation process.
Installation by press fitting.
They are designed for quick installation, used in soft and medium thermoplastics.
After installation the rivet nut is a little bit self-locking.
The rivet nuts for plastics are designed to be installed after the moulding.
Benefits of this solutions are:
• It is possible to place rivet nuts away from the moulding zone.
• "Press open" time reduced, consequent increase of the productivity.
• Scrap rate reduced, the risk of shifting of the rivet nuts during the moulding is eliminated.
• Installation can be automated.
While choosing always consider the type of plastics and the installation process.
Caractéristiques
| Marchio Statim | Rivit |
| modèle | RPLK080 |
| d. - diamètre (mm) | M8 |
| diamètre du trou (mm) | 9,6 |
| A (mm) | 10,0 |
| L | 12,7 |
| spessore parete (mm) | 4,8 |